Permits · Safety Standards Act · Updated November 2026
Permits and code.
Who is allowed to do the work in B.C., which permits a water heater needs, and what an inspector looks at.
By Andrew HendersonRed Seal Plumber
Who can do the work
Most gas and electrical work in B.C. is regulated under the Safety Standards Act. Technical Safety BC's position is that this work belongs to qualified people working for licensed contractors, with one narrow exception for homeowners.
| A licensed contractor | Can work on any home. Takes out the permit on your behalf. |
|---|---|
| You, under a homeowner permit | Only in a detached house that you alone own and that you and your family live in. Replacing a water heater is on Technical Safety BC's list of eligible homeowner gas work. The work is inspected. |
| A licensed contractor only | A house with a suite, occupied or not. A duplex, townhouse or condo. Any strata property. Any space used for business. |
Which permits
| Gas | Required for a gas water heater. A licensed gas contractor replacing a heater with one that vents the same way may use Technical Safety BC's replacement appliance decal in place of an individual permit. Changing how the heater vents, or going from a tank to a tankless heater, needs a full installation permit. |
|---|---|
| Plumbing | Issued by your municipality. The rules for a straight replacement differ from city to city, so ask your installer which applies to your address. |
| Electrical | Needed when wiring changes: a new circuit for an electric or heat pump water heater, for example. |
Depending on where you live, the gas or electrical permit comes from Technical Safety BC or from your municipality. Either way, ask for the permit or decal number and keep it with the invoice. Permits are a legal requirement in B.C., and insurers and home buyers ask for them.
What the code is protecting you from
| Overheating and pressure | A storage tank must have a temperature and pressure relief valve. Its discharge pipe has to run to a safe place and can never be capped. |
|---|---|
| Thermal expansion | The BC Plumbing Code requires protection against thermal expansion where the supply has a check valve, a backflow preventer or a pressure-reducing valve. In a house that usually means an expansion tank. |
| Earthquakes | Tanks are braced to the structure so they cannot fall and break their gas and water lines. |
| Scalds and bacteria | Hot water is stored at 60°C or more to control Legionella, and tempered before it reaches people. |
| Carbon monoxide | The vent must suit the heater and be proven to draw. Combustion air has to be available. |
| Gas leaks | The heater gets its own shut-off valve, and every joint is tested. |
| Water damage | Where a leak would damage the building, the tank sits in a drained pan. |
Signs the last installation skipped the permit
- No decal or permit sticker on or near the heater
- No straps holding the tank to the wall
- A relief valve with no pipe on it, or with a plug in it
- Flexible gas connector run through a wall or floor
- Tape, sealant or mismatched pipe on the vent
- Scorch marks or melted plastic on top of the tank
None of these is a reason to panic. All of them are worth showing a licensed gas contractor.
Questions
Do I need a permit to replace a hot water tank in B.C.?
For a gas tank, yes: the work is done under a gas permit or, for a like-for-like replacement by a licensed contractor, a replacement appliance decal. Plumbing permit rules for a straight replacement are set by each municipality.
How do I check that a contractor is licensed?
Ask for their Technical Safety BC gas contractor licence number and look it up with Technical Safety BC, which keeps a public search of licensed contractors. Pure Mechanical Group's is LGA0205758.
What happens if a water heater was installed without a permit?
It can be put right. A licensed contractor inspects the installation, corrects what does not meet code and takes out the permit. It is far easier to do before you sell the house or make an insurance claim than during either.
Sources
- Technical Safety BC: Making gas or electrical changes to your home
- Technical Safety BC: Homeowner gas permits
- Technical Safety BC: Directive D-GA 2012-01, Replacement appliance permit decals
- BC Plumbing Code 2018, Division B, Section 2.6 (thermal expansion, service water heaters)
- City of Vancouver: Building By-law plumbing summary (hot water storage temperature) (PDF)
More water heater help
This page is general information, not professional advice for your home. Gas, electrical and plumbing work is regulated in British Columbia. If you are unsure at any point, stop and call a licensed contractor. See the legal disclaimer.